Industrial - Decorative Visible Rail System

Product #: 2460120SSPVC


Interior Barn Door

The Industrial Barn Door Style sliding door kit with 2.0 m (78") upper track in stainless steel. The kit is made for door thickness of 35 to 45 mm (1 3/8" to 1 3/4"). The lag bolt and pre-drilled track makes for a simple installation

This is an economical product intended for residential light duty use.
Not recommended for high traffic commercial and hotel applications.

Please refer to the ALBERGO series for commercial and hotel applications.


Product number
Track Mounting
Wall Mount
Door Material
Stainless Steel (170)
Weight Capacity per Door
15 to 80 kg
Stainless Steel
Groove Needed for Guiding System
Groove Width at the Bottom of Door
5 to 7 mm
Groove Depth
20 mm
Number of Doors
Door Width
24 to 40 in
Door Thickness
1 3/8 to 1 3/4 in
Roller Type
Ball Bearing
Roller Position
Track Type
25 mm Tubing
Track Material
Stainless Steel
Track Finish
Stainless Steel
Track Length
2 m
Door Mounting Method


Ball bearings for easy movement.
Security: The system is equipped with an anti-derailment device for each bearing support to prevent the door from stalling when misused.


Interior access door


1 two-meter rail (tube)
2 single roller supports
2 bumpers
4 wall mounting brackets
1 door bottom guide
Screws are included


Door and door handle not included. To reduce operating noise, use a door that is heavier than the minimum weight: a solid wood door or a glass door is recommended. For privacy, it is best to use as door that is wider than the door opening. For example, a door 34" wide door is recommended for a 30" opening. The bottom of the door requires a groove for the concealed guiding system.

Preparation: Remove the moldings or install a piece of wood (not included) of the same length and thickness before setting the new hardware in place. This is to check door clearance. Ensure product is properly anchored/installed using anchors that are appropriate for the supporting material. Extra anchors that may be required are sold separately.

Picture is for visual reference only: actual product may vary from that shown in photo. Be sure to order hardware before beginning fabrication or installation work. Always use the instructions inside the packaging provided by the manufacturer, as the manufacturer reserves the right to make technical changes or modify information without prior notice.

All technical drawings and documents contain examples for the assembly of different supplier's hardware. Customer cannot make any claims based on the use of these documents. No responsibility is assumed for design details relating to the construction or project.

Installation should be undertaken by qualified persons. Ensure product is correctly installed using anchors that are appropriate for the supporting material. Never exceed manufacturer-recommended maximum weight or dimensions. Never use spray lubricant on these products. Use a dry cloth to remove all fragments, dust, and residue (sawdust and/or aluminum) from rails before the installation of the roller units.


Disclaimer: The preceding information as well as any technical recommendation given in writing, verbally or based on tests are provided to the best of our knowledge. However, they are non-binding recommendations only and do not affect your responsibility to determine the correctness of given recommendations and suitability of the product for your particular purposes. The application, use or processing of our products as well as the production of products based on our technical recommendations are beyond our control and therefore fall exclusively in your area of responsibility. Sales of our products are subject to our most recent General Sales and Delivery Conditions. Please note that Richelieu will not accept any returns or claims for unpackaged products.
Industrial - Decorative Visible Rail System

Product number: 2460120SSPVC