Square Glass Clamp - Round Post Mount - Model 506
|Product number||Manufacturing Material||Baluster Post Size||Recommended Location Usage|
|HRGCS450638170||Stainless Steel: 304||1 1/2 in*||Interior|
|HRGCS450642170||Stainless Steel: 304||1 21/32 in*||Interior|
|HRGCS650638170||Stainless Steel: 316||1 1/2 in*||Interior / Exterior|
|HRGCS650642170||Stainless Steel: 316||1 21/32 in*||Interior / Exterior|
45 mm height with detachable safety lock pin and safety plate
Set of four square clamps for installation of a glass panel between two posts.
The optional safety lock pin is included to keep the glass in place and prevent the glass from sliding.
An optional safety plate for face mount installation of posts included -- no pre-drilling required.
A set of protective joints, sold separately, is required for installation.
Requires ONE of the following products
Box of 4
Box of 4
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
No glass drilling required when using the safety plate.
End plate is equipped with rubber stops, to prevent the glass from moving after installation, even if used without the safety lock pin.
Stainless steel safety lock pin covered in rubber.
Detachable safety plate with rubber stop.
M8 mounting screws.
Glass drilling is required when using the safety lock pin.
Make sure to use proper joints according to the glass thickness.
For safety purposes, use tempered glass.
This illustration is provided for visual reference only. Actual product may vary. Order hardware before starting the job. The manufacturer reserves the right to change product and information without notice. Always follow the instructions inside the package.
Drawings and technical documents contain examples of hardware from different manufacturers. The customer may not in any case make a claim following the use of these documents. The Company disclaims any responsibility for the structural details related to a construction or project.
Installation must always be done by qualified personnel. Make sure that the product is properly installed using suitable fixtures on the support material.