Square Bracket for Glass with Drilling and Level Adjustment Screws
Recommended for use with laminated glass.
This bracket is designed to meet the increasing safety needs when installing balustrades with laminated glass requiring drilling, since compression isn't enough to keep the glass in place. The bracket has four adjustment screws at the base with a stainless steel plate to adjust the level and alignment of a series of panels when the horizontal surface is slightly uneven. These clamps are designed for a surface installation of glass panels, either inside or outside, such as around decks and pools.
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
- Ideal for balusters made of laminated glass
- No block torsion when pressure is applied
- This two-section clamp is designed to simplify the installation of laminated glass panels.
- The finishing plate covers the base and screws while giving the clamp an elegant look.
- Requires glass drilling for use.
The use of power tools during installation may damage the hinges and decorative hardware.
The glass must be shaped according to the section plane provided in the box. Maintenance: clean with a soft cloth and non-abrasive soap or ammonia.
This illustration is provided for visual reference only. Actual product may differ from the illustration. Order hardware before starting the job.
The manufacturer reserves the right to change product and information without notice. Always use the instructions inside the package.
Drawings and technical documents contain examples of hardware from different manufacturers. The customer may in no case make a claim following the use of these documents.
The Company disclaims any responsibility for the structural details related to a construction or project.
Installation must be done by qualified personnel. Always make sure that the product is properly installed using suitable fixings to the support material. Never exceed the load or maximum size recommended by the manufacturer. Never use a spray lubricant on this product.