Warranty
Concealed "T" Standard - No. 704 and 705
Product # 704062G
- 1/8" thick steel
- On center dimension from countersunk screw hole to countersunk screw hole is 6" staggered side-to-side
- Requires screw #10
- Loose fixtures and perimeter
- On center dimension from countersunk screw hole to countersunk screw hole is 6" staggered side-to-side
- Requires screw #10
- Loose fixtures and perimeter
TECHNICAL SPECIFICATIONS
Product #
704062G
Mounting
Concealed
Gauge
14
Width
1 1/2 in*
Slot Width
3/16 in
Slot Adjustment
2 in
Material
Steel
Color/Finish
Zinc
Disclaimer
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
APPLICATION
INSTALLATION
All wall mounted standards should be installed with the stamp right-side up, the widest margin at the bottom and typically a half slot at the top. Before mounting to the wall, line up each standard using the bottom of each bottom slot as the guide. Once aligned, make sure to fasten to a secure wall stud (or equivalent) using appropriate screws. Make sure to utilize each screw hole.
All recessed/concealed "T"-standards should be mounted right-side up as shown by the "top" stamp. Before mounting, line up each standard using the bottom of each bottom slot as the guide. Once aligned, make sure to fasten to a secure wall stud (or equivalent blocking) using appropriate screws (see Drawing A). Make sure to utilize each screw hole. Please note that a minimum 3/it by 1/s" notch is required in the stud or blocking to allow installation of brackets.
All wall mounted standards should be installed with the stamp right-side up, the widest margin at the bottom and typically a half slot at the top. Before mounting to the wall, line up each standard using the bottom of each bottom slot as the guide. Once aligned, make sure to fasten to a secure wall stud (or equivalent) using appropriate screws. Make sure to utilize each screw hole.
All recessed/concealed "T"-standards should be mounted right-side up as shown by the "top" stamp. Before mounting, line up each standard using the bottom of each bottom slot as the guide. Once aligned, make sure to fasten to a secure wall stud (or equivalent blocking) using appropriate screws (see Drawing A). Make sure to utilize each screw hole. Please note that a minimum 3/it by 1/s" notch is required in the stud or blocking to allow installation of brackets.
