Installation Instructions
End Bumper for Sliding Door System Aqua01
Product # 705AQUA01DHS170
Stops the door
Replacement bumper for sliding door system for frameless glass showers.
Rubber protectors prevent the glass from breaking when it reaches the bumper.
7 mm (9/32") diameter (rubber)
10.5 mm (13/32") length x 30.5 mm (1-13/64") (opening)
Rubber protectors prevent the glass from breaking when it reaches the bumper.
7 mm (9/32") diameter (rubber)
10.5 mm (13/32") length x 30.5 mm (1-13/64") (opening)
ADVANTAGES AND BENEFITS
Stops the sliding door when it is opened and closed.
Available in the most popular finishes on the market.
Available in the most popular finishes on the market.
REQUIRED PRODUCTS
Requires the following products
Length of 2 linear meter
TECHNICAL SPECIFICATIONS
Product #
705AQUA01DHS170
Application
Single Sliding
Finish
Brushed Nickel
Height
2 15/32 in*
Width
7/8 in*
Length
21/32 in*
Brand
Riveo
Material
Stainless Steel: 304
Disclaimer
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
APPLICATION
Simply insert the track of the sliding system inside the bumper opening. Predetermine the position for the bumper before installation and then screw onto the track by firmly holding into place. Make sure the rubber protectors are positioned toward the top and face the glass door. No glass drilling required for use. For interior use.