Hydraulic Patch Door Kit

To add to cart, choose from the options below.

Maximum opening at 150°

This hydraulic patch door kit includes top patch, pivot, and bottom mounted hydraulic hinge.
Available models include hold-open at 90°, 105° or non-hold options.
Finish: Brushed Stainless Steel Matte Black Satin Aluminum Function: Hold-Open 90° Hold-Open 105° No Hold-Open Select Options
Product # Finish Function
SSGWPF90170 Brushed Stainless Steel Hold-Open 90°
SSGWPF90900 Matte Black Hold-Open 90°
SSGWPF9010 Satin Aluminum Hold-Open 90°
SSGWPF105170 Brushed Stainless Steel Hold-Open 105°
SSGWPFNH170 Brushed Stainless Steel No Hold-Open
SSGWPF105900 Matte Black Hold-Open 105°
SSGWPFNH900 Matte Black No Hold-Open
SSGWPF10510 Satin Aluminum Hold-Open 105°
SSGWPFNH10 Satin Aluminum No Hold-Open


- Aligned pivot centers
- Easy to install and adjust
- Concrete fasteners included


Transom & Sidelite Mount, Transom Mount w/Sidelite, Transom Mount, Single Door, Transom & Sidelite Mount w/Sidelite
Glass Thickness
8 to 12.7 mm
Load Capacity
220 lb*

Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.


Suitable for 8 mm to 12.7 mm glass interior residential and commercial applications.
Recommended for use in areas with moderate traffic.
Maximum door width: 39 3/8 in (1000 mm)


For safety purposes, use tempered glass.
Do not use with laminated safety glass.
The glass must be shaped according to the section plane provided in the box.
The use of power tools during installation may damage the hinges and decorative hardware. Never use a spray lubricant on this product. Maintenance: clean with a soft cloth and soap that is ammonia-free and nonabrasive.

This illustration is provided for visual reference only. Actual product may vary. Order hardware before starting the job. The manufacturer reserves the right to change product and information without notice. Always follow the instructions inside the package.

Drawings and technical documents contain examples of hardware from different manufacturers. The customer may not in any case make a claim following the use of these documents. The Company disclaims any responsibility for the structural details related to a construction or project.

Installation must always be done by qualified personnel. Make sure that the product is properly installed using suitable fixtures on the support material. Never exceed the maximum load or size recommended by the manufacturer.



- Top patch fitting with cladding
- Pivot bracket
- Hydraulic bottom patch fitting with cladding
- Fasteners for concrete


The preceding information as well as any technical recommendation given in writing, verbally or based on tests is provided to the best of our knowledge.
However, recommendations are non-binding and do not diminish your responsibility for determining the correctness of these recommendations and the suitability of the product for your particular purpose.
The application, use or processing of our products as well as the production of products based on our technical recommendations are beyond our control and therefore exclusively your responsibility.
Sales of our products are subject to our most recent General Sales and Delivery Conditions. Please note that Richelieu will not accept any returns or claims for unpackaged products.