North American SDS
MULTIBOND 1060 - HOT/COLD PRESS VENEERED
Product # WEBSO1246017
Multibond 1060 is a one-part crosslinking polyvinyl acetate emulsion adhesive developed for a wide range of laminating applications. It can be used as an edge and face gluing adhesive. It is water-resistant and offers protection from bleed-through on thin veneers.
ADVANTAGES AND BENEFITS
KEY PRODUCT FEATURES
- A good choice for hot press laminating
- Bleed-through resistant
- Water resistant
- No added formaldehyde
- A good choice for hot press laminating
- Bleed-through resistant
- Water resistant
- No added formaldehyde
TECHNICAL SPECIFICATIONS
Product #
46051800
Viscosity
4500 cps
Weight
496 lb
Brand
Franklin Industrial
Features
Water Resistant
Base
Cross-linking Polyvinyl Acetate
Production Time
Special online order - 14 days
APPLICATION
Preparation of stock that will be glued is extremely important. Joints cut from rip saws should be free of saw marks. They should also be straight and square. Molded or jointed stock should be free of knife marks. Glazed or burnished joints will prevent adhesive penetration and should be avoided.
Gluing stock should be uniform in thickness. Variation in thickness should not exceed ± 0.005 in/0.12 mm.
Sanding to thickness should be performed using higher than 50 grit abrasives. When possible, glue joints should
be prepared and glued the same day.
Spreads of 35-50 pounds of adhesive per 1,000 square feet or 170-250 grams per square meter of glue line are adequate. Verify adequate glue coverage by monitoring for squeeze out along the glue line once the panels are under pressure.
Gluing stock should be uniform in thickness. Variation in thickness should not exceed ± 0.005 in/0.12 mm.
Sanding to thickness should be performed using higher than 50 grit abrasives. When possible, glue joints should
be prepared and glued the same day.
Spreads of 35-50 pounds of adhesive per 1,000 square feet or 170-250 grams per square meter of glue line are adequate. Verify adequate glue coverage by monitoring for squeeze out along the glue line once the panels are under pressure.
