Line art
Richelieu's 9W LED Power Supply
Product # 8990
Class II
Input: 110V ~ 240V 50/60Hz
Output: 700mA , 1~3 pcsx 3W LED
Primary Cord: SPT-2 200cm with polarized plug.
Secondary Cord: 1007 #20 20cm +:red -:black with 3-pin distributor connected by XH2.5 connectors
Ambient Temp.: -10°C~ +40°Cfull load
Maximum case temp.: 70°C
Operating Humidity: 20%~95% RH non-condensing
Protections: Short-Circuit / Over Heat
Output: 700mA , 1~3 pcsx 3W LED
Primary Cord: SPT-2 200cm with polarized plug.
Secondary Cord: 1007 #20 20cm +:red -:black with 3-pin distributor connected by XH2.5 connectors
Ambient Temp.: -10°C~ +40°Cfull load
Maximum case temp.: 70°C
Operating Humidity: 20%~95% RH non-condensing
Protections: Short-Circuit / Over Heat
REQUIRED PRODUCTS
Requires the following products
AND
AND
TECHNICAL SPECIFICATIONS
Product #
8990
Lighting Type
LED
Finish
White
Watts
9 W
Standards and Certifications
UL
Length
2 1/2 in
Width
1 1/3 in
Tension (V)
12 V
IMPORTANT INFORMATION
Always connect the LED light to the power supply first, and then connect the power supply to the mains. Failure to do so may cause damage to the existing diode. All unused power supply output plugs must have jumpers installed. Do not exceed the maximum wattage by connecting more lights than prescribed; damage to the power supply may result.
DISCLAIMER
Do not cut or splice wiring or the lighting system may be damaged and manufacturer's warranty is voided.
The power supply has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified technician. Never use an extension cord unless the plug can be fully inserted. Do not alter the plug.
The power supply has a polarized plug (one blade is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified technician. Never use an extension cord unless the plug can be fully inserted. Do not alter the plug.