Rustic Barn Door Hardware
The Diamond Kit - With 2 m rail
Hardware for a single sliding door
Complete set of visible steel hardware in satin brass finish designed for easy installation of a single standard size wood door. This single-roller hardware kit includes a 2 m (6 1/2') rail. Each rail is pre-drilled to allow for installation of soft-close mechanism at each end (sold separately).
- Technical specifications
- Suggested products
- Advantages and benefits
- Included Product(s)
- Important Information
- Related documents
|Track Mounting||Wall Mount|
|Number of Doors||1|
|Door Width||24 to 36 in|
|Door Thickness||1 3/8 to 1 3/4 in|
|Roller Type||Ball Bearing|
|Track Finish||Brushed Brass|
|Track Length||78 3/4 in*|
|Door Mounting Method||Screw|
|Weight Capacity per Door||33.1 to 220 lb*|
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
- Handles for Sliding Barn Doors
- Sliding Door Soft-Close Mechanisms
Rails are pre-drilled at every 450 mm (17.7") for the installation of 5 wall mounted brackets and at each end to allow for interconnection with other rails or the installation of a soft-close mechanism.
Safety: each roller unit is equipped with a device that prevents derailment during rough use of the door.
- 2 roller units for 34.9 mm (1-3/8") or 44.45 mm (1-3/4") thick door
- 2 end bumpers
- 5 wall mounted brackets
- 2 anti-derailment devices
- 1 floor-level door guide
Preparation: Remove the frame moldings or install a piece of wood (not included) of the same thickness and length before setting the new hardware in place to ensure there is enough clearance for the door. Always make sure that the product is properly attached or installed using appropriate fixings material. An additional anchor may be required for installation (sold separately).
This illustration is provided for visual reference only. Actual product may vary. Order hardware before starting the job. The manufacturer reserves the right to change product and information without notice. Always follow the instructions inside the package.
Drawings and technical documents contain examples of hardware from different manufacturers. The customer may not in any case make a claim following the use of these documents. The Company disclaims any responsibility for the structural details related to a construction or project.
Installation must always be done by qualified personnel. Make sure that the product is properly installed using suitable fixtures on the support material. Never exceed the maximum load or size recommended by the manufacturer.
Never use a spray lubricant on this product.
Always use a dry cloth to remove debris, dust and residues (sawdust and/or aluminum dust) from rails before installing hangers.