"Majig Light" Puck Light Jig Kit

Product # 9125RICKSJIG214

57 mm (2-1/4") and molded case

Revolutionary design eliminates false bottom/cabinet buildups.
Quickly and accurately install LED puck lights.
Install wire and puck lights in 5/8 in (15.87 mm) or 3/4 in (19.05 mm) panels without using a false bottom.

Forstner bits with adjustable stops for setting puck light depth. Single clamp ensures streamlined tool setup. Allows for drilling puck light and cable holes in less than one minute. Split-bushing design allows rapid chip relief through 4 in (101.6 mm) of precision alignment. Requires clamps and drill motor to operate. Hardened bushings carry a lifetime warranty.

TECHNICAL SPECIFICATIONS

Product #
9125RICKSJIG214
Type of Jig
For Luminaire Installation
Specification
Drilling Diameter 2-1/4" (57 mm)
Finish
Anodized Aluminum
Material
Aluminum
Hinge Plate Size
3/32 in*
Depth
11 3/4 in*
Drill Bit
3/32 in*
Weight
7.5 lb
Width
18 1/8 in*
Disclaimer

Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.

INCLUDED PRODUCT(S)

- Drilling template with bushings
- 2 1/4 in (57 mm) drill bit with adjustable stop collar
- 12 in (30.5 cm) x 3/8 in (9.5 mm) drill bit with stop collar
- 2 1/4 in (57 mm) Forstner bit
- Carrying case

APPLICATION

1. Set light depth with stop collar. Clamp, then drill light hole.
2. Drill wire hole with included drill bit.
3. Run wire through the panel and press in light.