Assembly instructions
Swivel Plate
Product # UC6612
Made of corrosion-resistant galvanized steel.
Swivel bearing design has a deeper race groove, encapsulating the balls more effectively and allowing them to move more smoothly.
Swivel bearing design has a deeper race groove, encapsulating the balls more effectively and allowing them to move more smoothly.
Product # | Features | Depth | Load Capacity | Width |
---|---|---|---|---|
UC6612 | With UPC Code | 15.2 cm* | 227 kg* | 15.2 cm* |
3312 | Without UPC Code | 76 mm* | 90.7 kg* | 76 mm* |
4412 | Without UPC Code | 10.2 cm* | 136 kg* | 10.2 cm* |
6612 | Without UPC Code | 15.2 cm* | 227 kg* | 15.2 cm* |
UC3312 | With UPC Code | 76 mm* | 90.7 kg* | 76 mm* |
UC4412 | With UPC Code | 10.2 cm* | 136 kg* | 10.2 cm* |
ADVANTAGES AND BENEFITS
Our swivel bearing design has a deeper race groove, encapsulating the balls more effectively and allowing them to move more smoothly.
TECHNICAL SPECIFICATIONS
Product #
UC6612
Swivel
360 Degrees
Material
Steel
Finish
Zinc
Height
7.94 mm*
Disclaimer
Measures shown with an asterisk (*) have been converted as per your preference. These are not the official measures. To view the measures specified by the manufacturer, click here.
IMPORTANT INFORMATION
Assembly instructions:
3" - 4" - 6" - 12" Sizes (Without Speed Nuts)
A. Use the smallest holes as a template to mark the turntable for blind fastening. Remove the bearing and then drill holes for self-tapping screws.
- For 3" - 4" - 6" sizes: drill 5/32" holes for #6 self-tapping screws.
- For 12" size: drill 3/16" holes for #8 screws.
- Avoid contamination from sawdust, paint or any other foreign material.
B. Lubricate the bearing balls with a small amount of heavy oil or grease. Mount the bearing on the selected center of the base using #6 wood screws.
C. Assemble turning section to the bearing. Make sure to select fasteners of the proper length to avoid interference with the opposite section.
3" - 4" - 6" - 12" Sizes (Without Speed Nuts)
A. Use the smallest holes as a template to mark the turntable for blind fastening. Remove the bearing and then drill holes for self-tapping screws.
- For 3" - 4" - 6" sizes: drill 5/32" holes for #6 self-tapping screws.
- For 12" size: drill 3/16" holes for #8 screws.
- Avoid contamination from sawdust, paint or any other foreign material.
B. Lubricate the bearing balls with a small amount of heavy oil or grease. Mount the bearing on the selected center of the base using #6 wood screws.
C. Assemble turning section to the bearing. Make sure to select fasteners of the proper length to avoid interference with the opposite section.